Rice Lake MSI-8000 RF Remote Display - Manual (Page 28)

lb kN MTon
1) Program a function key to Scan.
In this example we’ll use F1 for Scan.
2) The current channel is displayed.
Press F1 Scan to change the
display to the next channel.
3) The display briefly displays the
scan channel number. Then the
scan channel weight is
displayed.
4) Press F1 Scan . In a two sensor
system the scan returns to the
first channel, 0.
SCAN
See Function Key setup
on page 15.
lb
M
kN
Ton
  6F
Scan Weight Inputs
6F
SCAN
MOMENTARY
MOMENTARY
kg lb M kN Ton
F1
  F1
kg
24 MSI-8000 Operator’s Manual
Figure 5-4. Scan Weight Inputs
5.4 Summing Modes
The summing modes are straight forward and useful for the majority of overhead lifting
applications.
5.4.1 Modes
ALL
All channels are added together. Using the
Fx ttl.rd
function key, the sum of all connected
sensors are displayed. Pressing the
Fx ttl.rd
again will confirm that you are observing the
summed channels by briefly displaying “ttl.rd” (total remote sensor devices).
Note
If the sum is the only thing the user wants to observe, disable the Scan
function key using the function key setup menu.
PAIRS
Primarily intended for 4 sensor systems. When scrolling through the channels with an
Fx
ttl.rd
, the channels will be presented as separate weights first and then as pairs. This
display is proceeded by the LCD message “Pair1” and “Pair2.”
BOTH
This mode shows both the pair totals and the overall total. Each press of the
Fx ttl.rd
key
will scroll through the summed combinations. First “Pair1,” next “Pair2,” then the sum of
all connected sensors is displayed.
OFF
Sensor summing disabled. Even if a function key is set to “ttl.rd” nothing will happen.