Rice Lake Scout Pro Series Portable, Ohaus - Service Manual - Manual (Page 32)

A-4
APPENDIX A SERVICE TOOL INSTRUCTIONS
2. If the communications parameters have to be set, click on the Com Port tab and the screen
shown in Figure A-5 will appear. Adjust the parameters as required to match the balance.
Figure A-5.
A.5 USING CONFIGTOOL.EXE. (CONT.)
3. When the communications parameters are matched click on the Test Command tab and
test the communications.
4. In this example, see figure A-6, the “P” command resulted in the 0.02g being written in the
lower screen. The “V” command resulted in Sr: 1.10 being written. The T command had
the effect of zeroing the balance, and the last P command resulted in the 0.00g being
written. If the balance does not reliably communicate the problem must be fixed before
continuing.
Figure A-6.