Rice Lake TradeRoute HL Series - Operation Manual (Legal-for-Trade) - Manual (Page 27)

Maintenance 23
Use quality high-pressure grease.
Avoid bending or twisting the load cell wires.
4.3 Linkage Assembly/Disassembly
To perform service on any of the scale parts (e.g. load cell or bushings), the linkage
assembly must be disassembled. The following procedure must be followed when
disassembling any linkage.
Figure 4-2 Linkage Assembly/Disassembly (Double Cell Assembly Shown)
Tools required:
• 7/16" wrench or socket
• 3/4" wrench or socket
• 3/4" hex allen wrench (ratchet preferred)
• 1/4" roll pin punch
• Hammer
• Large flat head screwdriver
• 11/16" wrench (required for hydraulics only)
• 5/8" wrench (required for hydraulics only)
Important
24
25
23
26
27
28
10
4
18
5
13
11
15
14
9
8
2
20
22
19
21
3
22
1
56
Apply grease
both ends
Bushings
Bushings
Apply grease
Item numbers DO NOT
correlate with the
spare parts illustrations.
Note