Rice Lake TradeRoute HL Series - Operation Manual (Legal-for-Trade) - Manual (Page 28)

24 TradeRoute Operator’s Manual
4.3.1 Disassembly Procedure
1. Remove load cell cover bolts (27) and lock washers (28) with 7/16" wrench and
remove load cell cover (26).
2. Remove retaining ring (3) from lower cylinder pin with flat-head screwdriver.
3. There are two roll pins (22) inserted through the lower load cell pin (21). Remove
the roll pin at the end of the lower load cell pin that prevents the load cell assem-
bly from jumping off the pin.
4. Loosen jam nut (25) on lockdown bolt (24) and turn lockdown bolt in with 3/4"
wrench.
5. Loosen socket-head cap screw (10, 11) with 3/4" allen wrench.
The cap screw and sleeve are pressed together and should not be
separated. Sleeve will come out with cap screw.
6. Remove pivot-pin bolt (13), washer (15), and lock washer (14) with 3/4" wrench.
7. Remove socket-head cap screw (10, 11) and lift arm spacer (9).
8. Remove outer lift arm (5).
9. Remove upper load cell pin (18) and load cell assembly (19 and 20).
10. Remove upper cylinder pin (8) and hydraulic cylinder (2).
11. Remove inner lift arm (4).
12. Remove lower load cell pin (21) only if required by removing the second roll pin
(22) with roll pin punch and hammer.
Do not remove any hydraulic hoses unless you have a qualified person
to remove air from the system. The hydraulic lines do not need to be
removed to disassemble the system.
13. Remove hydraulic fittings (56, 57) only if required with 11/16" and 5/8" wrenches.
14. Check all bushings for excess wear. Replace the bushings if necessary.
15. Bushings in the lift arms have been installed with Loctite
®
. You may need to heat
the bushing to remove them.
16. Clean any Loctite that remains in the bushing locations.
Note
Note