Sage Oracle BES980UK - Manual (Page 16)

31 32
PAge heAder..... CArE & CLEAnIng
13
Lock hopper Remove beans Run grinder until empty Remove hopper
Remove upper
burr
Unlock hopper
1 2 3 4 5
6
Clean lower
burr with
cleaning brush
Remove Auger
fan with the
cleaning tool
Clean upper
burr with
cleaning brush
7 88 9
Clean grind
outlet with
brush
10
Insert Auger
fan with the
cleaning tool
11
Push upper
burr firmly into
position
12
Lock upper burr
14
Insert hopper
15
Lock hopper
CLEAnIng ConICAL BUrrS
Regular cleaning helps the burrs achieve consistent grinding results which is especially
important when grinding for espresso coffee.
CArE & CLEAnIng
8. Wipe the steam wand dry with a
clean cloth.
9. Discard solution & rinse jug
thoroughly.
notE
Clean steam wand and tip thoroughly
after every use. Failure to clean may
affect performance.
CLEAnIng tHE fILtEr BASKEtS
And PortAfILtEr
• The filter baskets and portafilter should
be rinsed under hot water after each
coffee making session to remove all
residual coffee oils.
If the holes in the filter baskets
become blocked, dissolve a cleaning
tablet in hot water and soak filter basket
and portafilter in solution for approx.
20 minutes. Rinse thoroughly.
CLEAr WAtEr BACKfLUSH
• After each coffee making session
we recommend doing a clear water
backflush before you turn off the
machine. Empty drip tray. Insert the
cleaning disk into the filter basket and
insert the portafilter into the group
head. Press the 1 CUP button and allow
pressure to build for 20secs, then press
to stop & release pressure. Repeat this 5
times to purge any fine coffee grounds
and residual coffee oils from
the brew water paths.
CAUTION
Descale & replace water filters when
prompted in the LCD. Contact Sage
customer service centre for advice.
CLEAnIng tHE StEAm WAnd
• Wipe the steam wand with a damp cloth
& purge directly after texturing the milk.
• If the any of the holes in the tip of the
steam wand become blocked, ensure the
steam lever is in the CLOSED position
and clean using the pin on the end of
the cleaning tool. Even partially blocked
holes may affect the performance of
the Auto Steam function to produce
sufficient foam volume.
• If steam wand remains blocked, remove
the tip and soak together with steam
wand using the Steam Wand Cleaner
Powder. Please refer to manufacturer's
instructions on pack. Screw tip back
onto the steam wand after rinsing.
• The steam wand can be left immersed
in the jug with water when not in use to
reduce the risk of blockages.
milk Cleaning Sachets
1. Add 1 sachet into an empty milk jug.
2. Add 1 cup (250ml) hot water into
milk jug.
3. Remove steam tip and place with
steam wand into jug.
4. Leave to soak for 20 minutes.
5. Clean and replace steam tip, place
wand back into the jug and activate
steam cycle for a 10 seconds.
6. Allow to soak for 5 minutes.
7. Purge several times & rinse
thoroughly.