Welch Allyn 6000 Series Connex Vital Signs Monitor - User Manual - Manual (Page 183)

Specify radio settings
This task is applicable only to monitors that have a radio installed.
1. Access the Advanced Settings.
a. Touch the Settings tab.
b. Touch the Advanced tab.
c. Enter the Advanced settings code.
d. Touch OK.
The General tab appears.
2. Touch the Network tab.
3. Touch the Radio tab.
4. Specify settings.
Setting Action/Description
Enable radio Enable the radio for device communications. When
disabled, the radio is not available.
Enable radio network alarms Activate radio network alarms when an alarm condition
occurs. When disabled, radio network alarms are not
available.
SSID Touch and enter the service set identifier
(SSID). SSIDs that are longer than 16 characters may be
truncated in the user view. Enter a maximum of 32
characters.
Radio band Select the radio band.
Authentication type Select an authentication scheme. Then specify any
additional settings that appear.
Method Select a method. Then touch and enter
characters: Network key (64 characters), or
Passphrase (8 to 63 characters).
Note The characters you enter for Network key and
Passphrase appear as asterisks on the keyboard and
then on the Radio pane.
Security protocol Select the security protocol.
EAP type Select the EAP type.
Identity Enter the EAP identity (maximum of 32 characters).
Password Enter the EAP password (maximum of 32 characters).
Key number Select the WEP key number.
Key Enter the WEP key (10 characters for WEP 64, or 26
characters for WEP 128).
Configure radio Touch Configure radio to activate all new radio
settings not selected previously.
Touch OK in the confirmation popup telling you to
power down the monitor.
Touch the Settings tab. Touch the Device tab.
Touch Power down .
The radio will reboot.
Directions for use Advanced settings 177