Welch Allyn 6000 Series Connex Vital Signs Monitor - User Manual - Manual (Page 33)

2. Depress the spring tab on the temperature probe cable connector and withdraw it
from the probe port.
3. Reattach the cover. Use the alignment tab and slide the cover to the left to click it
back into place.
Grasp the probe well and pull it up to remove it from the monitor.
Connect the NIBP hose
1. Place your thumb and forefinger on the hose connector and squeeze the side tabs.
2. Align the hose connector with the hose connector port on the side of the monitor.
3. Insert the hose connector, pressing firmly until it clicks into place.
Disconnect the NIBP hose
1. Place your thumb and forefinger on the hose connector.
Note Always grasp the hose by the connector. Do not pull on the
hose itself.
2. Squeeze the side tabs until the connector releases.
3. Pull the connector away from the connector port.
Connect the SpO2 cable or the SpO2/RRa dual cable
WARNING Patient injury risk. Do not use a damaged sensor or pulse
oximetry cable or a sensor with exposed electrical or optical components.
Follow these steps to connect the SpO2 cable or the SpO2/RRa dual cable to the SpO2
port on the monitor. The location of the port on your monitor might differ from that
shown in the images below.
Note For monitors configured with SpHb, the sensor used to monitor SpHb also
measures SpO2.
Connect the SpO2 cable
1. Place your thumb and forefinger on the cable connector and squeeze the side tabs.
Directions for use Setup 27