Carrier Access Multi-Service Router (MSR) Card MSR/Adit 3K GUI - Manual (Page 120)

3-10 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) GUI
Network Connections
Preconfigured Connections
Configuring Ethernet 2
To change the configuration of Ethernet 2, select the Settings button and modify the settings as
necessary. Select Apply when finished. The following are the field definitions for the Ethernet 2
settings:
Field Definition
General
Device Name Displays the device name.
Status Displays the current status (Disabled, Connected, ...).
Schedule Availability Defines when the WAN is available. The default is Always. To create a
Schedule Availability rule, click New.
Network Defines the type of network:
WAN - Wide Area Network (Default).
LAN - Local Area Network
DMZ - Demilitarized Zone
Connection Type Displays the connection type (Ethernet).
MTU Maximum Transmission Unit. Sets the largest packet size (bytes) the
network will transmit:
Automatic at 1500.
Manual at a range of 576 to 1500.
Speed/Duplex Sets the speed and duplex behavior for the Ethernet interface:
Auto - Auto-negotiate the speed and duplex for the interface. Default.
100T-FD - 100 Mbps speed and full-duplex.
100T-HD - 100 Mbps speed and half-duplex.
10T-FD - 10 Mbps speed and full-duplex.
10T-HD - 10 Mbps speed and half-duplex.
Internet Protocol
Obtain an IP Address
Automatically
Sets the connection to use DHCP to obtain an IP address.
Override Subnet Mask - Set specific mask.
DHCP Option Auto Provision - Enable DHCP auto provisioning.
Rx TOS Marking - Enable IP TOS marking.
Rx TOS Value - Hex value, range 0x00-0xFF, default is 0x00
Use the Following IP
Address
IP Address - Sets the IP Address
Subnet Mask - Sets the Subnet of the IP Address
Default Gateway - Sets the Default Gateway IP Address.
Rx TOS Marking - Enable IP TOS marking.
Rx TOS Value - Hex value, range 0x00-0xFF, default is 0x00
DNS Static Entries (this name is a link to the Advanced/DNS Static Entries window) Note: This field
appears when Internet Protocol is set to Obtain an IP Address Automatically
Obtain DNS Server
Address
Automatically To automatically obtain the DNS Server Address.
Use the Following
DNS Server
Addresses Primary DNS Server - Enter the specific DNS server address to use.
Secondary DNS Server - Enter a secondary DNS server address to use.