Carrier Access Multi-Service Router (MSR) Card MSR/Adit 3K GUI - Manual (Page 152)

3-42 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) GUI
Network Connections
OSPF Configuration on the Network Connection
4. Set the OSPF interface parameters as needed:
Field Definition
Interface
Authentication
Interface
Authentication
Type None - Set the OSPF Authentication to none.
Simple Authentication - Enable Simple Authentication on the OSPF Interface.
Authentication Password - Enter password with a maximum 8 characters.
Message-Digest - Enable Message-Digest Authentication on the OSPF Interface.
Message Digest Key - Enter key, with a maximum 8 characters.
Message Digest Key ID - Enter Key ID, with a range of 1-255.
Using Area Authentication - Enable OSPF area authentication. See OSPF on
page 2-47 for information about configuring OSPF area authentication.
Interface Parameter
Retransmit
Interval Defines the interval of time between link state advertisement retransmissions for
adjacencies belonging to the interface.
Range is 1-65536 seconds, with a default of 5.
Transmit Delay Defines the estimated time to transmit a link state update packet on the interface.
Range is 1-65535 seconds, with a default of 1.
Dead Interval Defines the interval of time that no hello packets have been seen before
neighbors declare the router down. Range is 0-65535 seconds, with a default
of 40.
Note: This value must be the same for all nodes on the network.
Hello Interval Defines the interval of time between hello packets that the Adit sends on the
interface.Range is 0-6553516383 seconds, with a default of 10.
Note: This value must be the same for all nodes on the network.