Carrier Access Multi-Service Router (MSR) Card MSR/Adit 3K GUI - Manual (Page 178)

4-24 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) GUI
Security
Remote Administration
Configuring Remote Administration
To configure remote access to Adit administration services:
1. Select Security/Remote Administration.
2. Select the services that you would like to make available to computers on the Internet. By
default, all fields are unselected (disabling all remote services):
3. Select OK.
Field Definition
Allow Incoming Access to the Telnet Server
Grants command-line access to the Adit. While this service is password-protected, it is not considered
a secure protocol.
Using Primary Telnet Port (23)
Using Secondary Telnet Port (8023)
Note: If a local server is configured to use port 23, select port 8023 to avoid
conflicts.
Using Secure Telnet over SSL Port (992)
Allow Incoming Access to the Web-Management
Using Primary HTTP Port (80)
Using Secondary HTTP Port (8080)
Using Primary HTTPS Port (443)
Using Secondary HTTPS Port (8443)
Allow SNMP Control and Diagnostic Requests
Allow Incoming SNMP Requests
Diagnostic Tools
Includes Ping and Traceroute (over UDP). These services may be used for troubleshooting and
remote system management by the service provider.
Allow Incoming ICMP Echo Requests
Allows Pings and ICMP traceroute queries.
Allow Incoming UDP Traceroute Queries
Allows UDP traceroute queries.