Carrier Access Multi-Service Router (MSR) Card MSR/Adit 3K GUI - Manual (Page 134)

3-24 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) GUI
Network Connections
Connections that Require Configuration
DNS Static Entries (This name is a link to the Advanced/DNS Static Entries window.)
Obtain DNS Server
Address Automatically Sets the interface to obtain a DNS Server address.
Use the Following DNS
Server Address Sets the DNS Server Address.
Primary DNS Server - Enter the specific DNS server address to use.
Secondary DNS Server - Enter a secondary DNS server address to
use.
Routing
Routing Mode Displays the current routing mode.
Route - Routing is used if public is visible on both sides.
NAPT - NAPT is used if doing private IPs on the Ethernet side or if
you want to hide specific publics on the internal side.
SIP ALG This field allows the customer to turn off the SIP ALG on external
interfaces.
Checked - the SIP ALG will be switched off.
Unchecked - the SIP ALG will not work.
Device Metric Value of Metric of IP network on this interface in the Routing Table.
Range is 0-255, with a default of 20.
Default Route Check to enable default route.
Routing Protocol None - Disable the routing protocol on this interface.
OSPF - Set the routing protocol to OSPF on this interface. There is a
link below the option to configure OSPF.
RIP - Set the routing protocol to RIP on this interface.
Listen to RIP Messages - None, RIPv1, RIPv2, RIPv1/2
Send RIP Messages - None, RIPv1, RIPv2 - Broadcast, RIPv2 -
Multicast
Internet Connection
Firewall Note: This name is a link to the Security window
Enables/Disables Firewall for this device.
Additional IP Addresses Opens a window to add an additional IP address with subnet mask.
Field Definition (Continued)