B&C Technologies SI Series Industrial - Manual (Page 30)

Figure 5.6: External Chemical Supply Connection Detail
5.11.1 Chemical Connection
The supply compartment on the B&C SI models is located on the left front side of the machine.
Supply cups can be accessed by opening the dispenser lid. The supply cups can be removed and
filled as desired. Supply compartments are numbered 1,2,3,4 and 5 from the left to the right.
The five cup supply dispenser will flush each cup when Detergent 1 through Detergent 5 is pro-
grammed. The programmed chemical signal also appears as a 24VAC signal at the external chem-
ical terminal strip for the duration of each programmed signal.
External supply connections for the B&C SI washer-extractors are located on top of the supply
dispenser. Hose connections should be made via the strain relief.
1. Remove plugs from base. See figure. Plugs are assembled inside the tubing ring.
2. Install strain relief, included in the seal nut.
3. Insert tubes through base. Do not remove cups. Tube should extend into the plastic cup,
with the exception of the softener tube, which should be routed to the outside of the cup.
4. Tighten the seal nut to prevent tubing from escaping the assembly.
See figure 5.7 on page 27.
26