B&C Technologies SI Series Industrial - Manual (Page 39)

• Home Position - Machine is level, Chute is in the up position and Door is closed (this is the
starting position for any operator function).
• Chute Enable - Tells the machine to lower the Chute when Load switch is selected
• Chute Disable - Chute will stay locked in the up position when Load/Unload is selected
• Load - When Chute Enable is selected, Starts the loading operation, door opens, Chute move
down, Machine tilts back and start to jog automatically, and the water valve can be operated
• Load - When Chute disable is selected, The door is opens, machine will tilt, and Jog buttons
are enabled on pendant
• Unload - When Chute Enable is selected the door will automatically open, the machine will
tilt forward and the Jog buttons are enabled
• Unload - When Chute Disable is selected, the door will automatically open, the machine will
tilt forward and the Jog buttons are enabled
NOTE: The machine must be in HOME position before switching from Enable to Disable or
Disable to Enable. Home is always the starting position of any operation (Switching between
Unload and Load is allowed).
NOTE: Anytime there is a power loss or E-STOP is pressed the Safety Locks will automatically
attempt to go to the Locked position. If they fail to unlock upon restoration of power, use the
Maintenance Switch located in the rear of the machine.
Refer to figure 6.2 on page 36 for maintenance switch details. WARNING! Chute up switch is
for MAINTENCE ONLY!
NOTE: Switch is located inside the electrical panel
Move Home switch to Home on pendant. Activating the Maintenance switch will unlock the
Safety locks and move the Chute to the full up position.
6.4 Wash Program Execution
After power is applied to the machine, and the internal diagnostics are complete, the machine is
ready for a program to be chosen. The display will show:
PROGRAM N.
Using the keypad, type the number of the program you wish to run followed by the ENTER key.
Standard programs are outlined in the EL6 stock program list, included with the machine. The
display will change to show the fist cycle of the selected program:
35