B&C Technologies IS Series Commercial Ironer - Manual (Page 34)

Figure 5.5: Typical Bearing Grease Point
Figure 5.6: Typical Cam Follower (Cylinder Support) Grease Point
Inspect the compression roll and ensure that the pressure is correct. The compression roll should
only slightly touch the ironing cylinder and not exert too much pressure.
For steam models, inspect the rotary steam joint for leaks. If a leak is noted, a repair kit is available.
Refer to the parts manual for details.
Caution: DO NOT touch or get too close to the steam piping. EXTREMELY HOT!
Clean the exhaust system, including blower and ductwork.
Clean the AC drive cooling fan and heat sink, located on the underside of the drive.
Clean the ironing cylinder, removing any residue.
Clean the steam trap filter (obviously, steam models only.). See Figure 5.7 for typical trap.
Figure 5.7: IS Series - Steam Trap Illustration
31