Programming, Motor programming continued – B&C Technologies EL-6 Programming (SA, SB, SI, SP, HI, HP Series) User Manual
Page 10
Programming
Motor Programming continued
Notes on Motor Programming
There are a number of different modes
available for motor programming:
1. Forwards - Pause - Backwards
T. FORWARD = XXs
T. PAUSE = XXs
T. BACKWARDS = XXs
2. Forwards - Pause
T. FORWARD = XXs
T. PAUSE = XXs
T. BACKWARDS = S0
3. Forwards
T. FORWARD = XXs
T. PAUSE = S0
4. Pause - Backwards
T. FORWARD = S0
T. PAUSE = XXs
T. BACKWARDS = XXs
5. Backwards
T. FORWARD = S0
T. PAUSE = S0
T. BACKWARDS = XXs
The minimum pause time that can be
programmed between forward and backwards
is 2 seconds. The maximum time is 239
seconds.
Cylinder speed is programmed during cycle
programming. In this mode, each step can be
programmed with different values if desired.
B&C Stock Motor Assignments
9
Motor Number
Forward
Pause
Reverse
1
16
4
16
2
4
16
4
3
5
115
5
14
0
0
1
15
1
0
0
Motor 1 - used for normal wash agitation.
Motor 2 - used for gentle wash agitation.
Motor 3 - used for soak formulas
Motor 14 - Used for Unroll cycles (reverse only)
Motor 15 - Used for Spin cycles (forward only)