B&C Technologies EL-6 Programming (SA, SB, SI, SP, HI, HP Series) - Manual (Page 18)

17
Programming
Cycle Programming continued
Editing an existing cycle
If the cycle you chose already exists, the display
will show:
EXISTING!
At this point, four choices are possible:
K Choose another cycle by pressing STOP
L Access the existing cycle by pressing
ENTER (to edit step 1), or press
ADVANCE to edit other steps. In this
case, INC or DEC will display the
various segments, and the configuration
can be modified by using the ENTER
and RESET keys to enable/disable a
function, or using ENTER to modify any
numerical value (RPM, Time, etc.) as
described in the previous section.
M Insert one or more steps. To do so,
scroll through the steps by using the
ADVAN key. The display will show
START STEP X for two seconds,
followed by EXISTING! To insert a step,
press INS. The new step is inserted as
the current step, and all later steps are
increased by one. For instance, if the
display showed Start Step 2 existing,
and the INS key is pressed, a new step 2
is created, and the old step 2 is now step
3, the old step 4 is now step 5, etc. and
the display changes to:
START STEP x
COOLDOWN? NO
Followed by:
You may now proceed to program the new step
using the techniques described earlier. After
confirming storage of the new steps, press
STOP.
N
Remove one or more of the steps from
the existing ones. Proceed by pressing
ADVAN as describe above in (3). When
the message
EXISTING!
appears after the step you wish to
remove, press the DEL key. The
following message appears:
DELETE?
To confirm deletion of the step, press the
ENTER key or press RESET to cancel the
operation. After confirmation, press the STOP
key to exit.
Each cycle can comprise a maximum of 100
steps.
A total of 400 steps can be programmed.
See the EL6 Stock Programs Listing, included
with your machine, or available from our
website (http://www.bandctech.com) for details
of the cycles included with your machine from
the factory.
Note: The factory programs and cycles can be
altered at will. There is no way to restore the
factory programming without manually
inputting them, or via download with the EL6
Win 2 programming software, also available for
download on our website.