B&C Technologies EL-6 Programming (SA, SB, SI, SP, HI, HP Series) - Manual (Page 9)

Programming
8
Motor Programming
To access the motor programming mode, press
START and RESET together. The display
shows:
n?
Enter 45 at this prompt, followed by the
ENTER key. For two seconds, the display will
show:
* EDIT MOTORS *
You are then asked to enter the motor routine
number to be programmed (1 - 15).
MOTOR No.
You may now enter the number and press the
ENTER key. There are now two cases:
1. The motor routine does not exist.
2. The motor routine does exist.
New Motor Routine
In this case, you are prompted to enter a
clockwise rotation time with this message:
T. FORWARD = S
Enter the desired time in seconds (0 through
239), followed by the ENTER key. The display
will change to:
T. PAUSE = S
Enter the desired time in seconds (0 through
239), followed by the ENTER key. The display
will change to:
T. REARWARDS = S
Enter the counterclockwise time in seconds (0
through 239), followed by the ENTER key.
The display will show:
Pressing ENTER will store the motor timing
routine and the display will change to request a
new access code:
n?
Enter 45 at the prompt to program additional
motor timing sequences as required. Pressing
RESET instead of ENTER will exit
programming.
Editing an Existing Routine
If the motor routine number you entered is
already present, the display will show:
EXISTING!
Pressing the INC and DEC keys allow you to
step through the values for Forward, Pause,
and Backwards. Pressing ENTER will allow
you to modify the value on the display
After having viewed or modified the backwards
value, pressing the INC or ENTER key displays:
Pressing the ENTER key again displays the
forward rotation time:
T. FORWARD = XXs
STORE?
STORE?
Pressing ENTER confirms the changes made (if
any) and exits programming
Pressing RESET exits the current programming
mode and leaves the existing values as they
were.