B&C Technologies EL-6 Programming (SA, SB, SI, SP, HI, HP Series) - Manual (Page 13)

Cycle Programming Sequence
12
Hard Water
3
INC
Relay 16
3
INC
Relay 11
3
INC
Relay 12
3
INC
Relay 13
3
INC
Motor
3
INC
RPM
3
INC
Relay 17
3
INC
Relay 18
3
INC
Relay 19
3
INC
Yes to turn on chemical signal 5, and
flush cup 5 in the supply dispenser, if
equipped. No means the supply is off.
Not Used
Yes turns on Auxiliary Fill.
No means the valve is off.
Injection flush - only used on machines
with stainless steel vacuum breaker.
No means the supply is off.
Yes turns on drive balance relay - only
used in extract cycles. No means the relay
is off.
Yes enables the machine to rotate, in
concert with RPM, below. No means
no cylinder rotation. More information
on page 8.
Set the RPM - see chart on page 29 for
details on recommended speeds for a
particular machine.
Yes to turn on chemical signal 6.
No means the supply is off.
Yes to turn on chemical signal 7.
No means the supply is off.
Yes to turn on chemical signal 8.
No means the supply is off.
continued
To turn on a function, press Enter, to turn off a function press Reset. Press Enter to edit a numerical
value (RPM, Time, etc.). Note: Setting a function to zero DOES NOT disable that function.