B&C Technologies EL-6 Programming (SA, SB, SI, SP, HI, HP Series) - Manual (Page 21)

Programming
Wash Program Creation continued
20
STOP key when the display changes to:
STORE?
Confirm by pressing the ENTER key. The cycle
in question will be deleted, and the cycles
following will be decremented by one.
Inserting a Cycle
To insert a cycle, use the INC and DEC keys to
find the cycle that will follow the cycle you are
about to insert. The new cycle will be inserted
just before the cycle displayed. Now press the
INS key, the request to enter a new cycle will be
displayed:
C -> ?
Press ENTER to confirm that you wish to insert
a new cycle:
Cn> PREWASH=?
Use the INC and DEC keys to go to the
required cycle type and press ENTER to
confirm. You will then be asked to enter the
cycle number:
Cn> PREWASH=N
After entering the cycle number and pressing
the ENTER key, you can leave programming by
pressing STOP. The display changes to:
STORE?
Press the ENTER key to store the altered
program. All the following cycles will be
incremented by one. If you don’t want to
change the program, press the RESET key
rather than the ENTER key. This will cancel all
modifications made.
See the EL6 Stock Programs Listing, included
with your machine, or available from our
website (http://www.bandctech.com) for details
of the cycles included with your machine from
the factory.
Note: The factory programs and cycles
can be altered at will. There is no way
to restore the factory programming
without manually inputting them, or via
download with the EL6 Win 2
programming software, available on the
technical service page of our website.