Hit Products Pro-Two - Manual (Page 15)

WWW.RAINPROCO.COM WWW.RAINPROCO.COM
PRO 2 3
Position 4
To establish program start times, use set 1 to choose the desired program, use set 2 to
choose the start number, (always use start #1 for the first start time after midnight and so
on through start #6 as desired use set 3 to set the hour (A.M. and P.M.) of the start time,
use set 4 to set the minutes.
NOTE:
The Start Time is part of the first leg of a pre-programmed function called “Diamond Set
is part of the first leg of a pre-programmed function called “Diamond Set -
tings” tings” Refer to Diamond settings at the end of this programming guide for full details. Refer to Diamond settings at the end of this programming guide for full details.
Position 5
To review the total run time in a specific program, use set 1 to choose the program num-
ber. The total run time of that specific program is shown in the lower right hand position
of the display. You can review the water budget setting along with the total run time in
this position. If the water budget is changed from the default of 100%, the total run times
will change in this position, but in position 2, the valve run times will stay as inputted. The
actual running of the valve is determined by the input in position 2 multiplied by the water
budget setting in position 8. To review the numbered day of the calendar the controller
is currently on, use set 1 to choose the program desired. The day of the calendar will be
displayed directly right of the word “DAY” in the upper display. You can change the day of
the calendar by using set 3 buttons. This will or can bring all days of all programs to the
same day for calendar purposes. When a 7 day Calendar has been selected. The day of
the week will be displayed.
Note: By adjusting the budget up or down (0% to 250%) it will change the total run time.
See position 8 for further discussion. The budget is the second leg of the Diamond Set-
ting.
Total Run Time
Start Time