Hit Products Pro-Two - Manual (Page 19)

WWW.RAINPROCO.COM WWW.RAINPROCO.COM
PRO 2 7
Manual — Press set 3 to activate manual mode, use set 1 to choose the specific valve
number to be operated manually for a predetermined time, use set 2 to set amount of
hours to run, use set 3 to set amount of minutes, use set 4 to tell the controller whether or
not you want the master valve or the pump start on during this manual operation. Valve
will immediately be activated for that period of time. Leave the dial in number 10 posi-
tion. [Rotating the dial will cancel the program.] At the conclusion, the controller will
resume the Auto Function without turning the rotary switch back to the “RUN” position.
You can activate up to 4 valves at the same time in manual mode.
Note: 30 minutes after the conclusion of the selected valves the controller will automati-
cally revert to the “RUN” condition.
Program Clear
Program Clear : Use set 4 to choose program clear, use set 1 to choose the program
that you desire to clear all the information from, use set 4 to answer yes.
Note: By clearing the program all information for that program is deleted.
Master Clear will clear all the information in the controller by way of the following: Turn
Master Clear Master Clear
rotary switch to position 10, press set 4, two times.
Note: All programming data in all programs will be deleted. Only the current time and
date will remain.
Note: Semi/Manual mode can be operated when controller is in “OFF” mode.
Position 11
Days of delay Days of delay (controller will not run for the number of days set) press set 1 for the num-
ber of days of delay, remember the new day starts at midnight.
Rain Sensor To set the Controller to recognize a Rain Sensor use set 3 button to set to
To set the Controller to recognize a Rain Sensor use set 3 button to set to Rain Sensor Rain Sensor
ON. When a Rain Sensor is not used leave setting OFF See Diagram.
Auto Functions Use Set 4 buttons. When OFF No Auto Functions will occur. The Man-
ual and Semi Auto Functions can be used and the controller will keep day and time.
Position 12
In the “Run” position the controller will execute all that it has been instructed to do. Add-
ing new or changing existing information can be done at anytime, even with a program
running. As soon as dial is rotated and new instructions are input, the controller will inter-
rupt any on going activity and accept the new instructions. When the dial is returned to
the “Run” position scheduled activity will resume.
To Program Decoders see PRO 2 Decoder Programming Instruction pg13.
Delay Rain ON/OFF Auto ON/OFF
Run Program Decoders