Hit Products Pro-Two - Manual (Page 22)

WWW.RAINPROCO.COM
20 PRO 2
WWW.RAINPROCO.COM
Programmable Decoder Number Identification Tags
Hit Products has developed a user friendly, flexible means to identify the number of the
field-programmed decoders during the decoder programming process. Inside every box
of programmable decoders, you will find one set of identification tags numbered 1-16.
You will use these decoder identification tags as follows:
1. Every time a decoder is programmed, find the corresponding numbered identification
tag and immediately attach to decoder.
2. To attach identification tag to decoder, insert one red decoder wire into the hole (from
front to back) to the left of the appropriate numbered tag as you are looking at the num-
ber. Pull red wire all the way through the hole until identification tag is approximately one
inch from body of decoder.
Note: This will leave the engraved number unobstructed by the wire.
3. Insert same end of same red wire back through hole (from back of tag towards front)
and continue to pull wire through until tight. The number on the tag should now be read-
ily visible
4. Should decoder ever be reprogrammed to a different number, make sure to replace
the identification tag with the appropriately numbered identification tag. Failure to do so
can create extreme confusion!