Pigtronix Infinity Looper - Manual (Page 10)

CHAPTER 2. ANATOMY AND FUNCTIONS 9
For more options and details, see the Infinity Rules Input Split section
on page 24.
Series Loops
When Series Loops is on, you are in Series mode. This means that
only one of the two loops can play at any given time. This is handy
for verse/chorus-type song structures.
When Series Loops is off, you are in Parallel mode. This means that
Loop 1 and Loop 2 can play together at the same time.
Sync Multi
Holding the Sync Multi switch will toggle Sync Multi on or off.
Quickly pressing the Sync Multi switch once Sync Multi is on, cycles
through the sync multiplier factor.
When Sync Multi is off, none of the sync multi lights are lit. In this
mode, the lengths of the two loops are unrelated and playback is not
synchronized.
When Sync Multi is on, the lengths of the two loops are synchronized.
The length of Loop 2 will be a multiple of the length of Loop 1, as
set by the multiplier factor indicated by the LED bar to the right of
the sync multi switch.
Loop 1 sets the initial length. Once recording on Loop 2 is initiated,
the Arm light will blink and it will wait to begin recording until the top
of the next loop cycle. Loop 2 will automatically stop recording and
begin playback when the proper length multiple has been reached.