Pigtronix Infinity Looper - Manual (Page 47)

8. Firmware Updates
8.1 Automatic Update Using the Looper
Application
In order to launch the Infinity Looper Application, you must plug the
looper into a PC using the supplied USB-A to microUSB cable. The
Infinity is not a bus powered device and must be plugged into the
wall using the supplied adapter in order to run the Infinity Looper
Application.
Once the Infinity has been connected to a computer, it will appear as
a USB mass storage device.
Open the drive that appears and double click on the appropriate (MAC
or PC) folder then double click the Space Pig icon to launch the Infinity
Looper Application.
Make sure your computer has an active internet connection.
Choose the firmware update option from the Tools menu within the
Infinity Looper Application. Choose the “automatic” option.
Close the Infinity Looper Application.
Power down the Infinity Looper (eject first on MAC) and then discon-
nect the USB cable from the Infinity Looper.
While holding down the Input Split switch, reconnect the power sup-
ply. The digit will display an “F” to indicate the firmware update
process has been initiated. When finished, the Infinity will re-boot
automatically and your firmware will be updated.
46