Pigtronix Infinity Looper - Manual (Page 38)

CHAPTER 5. EXPRESSION PEDAL FUNCTIONS 37
You can use a simple momentary switch (connected via TRS) in place
of an expression pedal to get an instant Loop Replace function out of
the “A” mode, since hitting the switch is like going to “0.”
5.3 Varispeed
This is the default function of the Expression pedal while in the
Varispeed Remote Control Menu. This mapping controls the Varispeed
sample rate. Moving the expression pedal towards the heel will de-
crease the sample rate, decreasing pitch and increasing loop length.
When the Expression Pedal is moved it takes control of the sample
rate and will remain in control until the Pitch Up or Down functions
of the Varispeed Remote Control Menu are used. Once the Pitch
Up or Down functions have been used the Expression Pedal must first
“Catch Up” the the Remote Switch setting before it begins controlling
the sample-rate again.
5.4 Expression Pedal Assignment
When shipped from the factory or Reformatted (as described on page
32), the Expression Pedal is assigned to control Loop Volume ex-
cept while in the Varispeed Remote Control Menu when it controls
Varispeed.
The Expression Pedal can be assigned using the Application or using
the Remote Mapping Menu.
The Remote Mapping Menu is accessed by pressing the Series Loops
switch for 2 seconds. The digit will flash “P” and the current Ex-
pression pedal assignment (either “U”, “A”, or “≡” for Loop Volume,
Loop Aging, or Varispeed respectively). Move the encoder to select
the desired Expression pedal mapping and press the Preset Encoder