Pigtronix Infinity Looper - Manual (Page 30)

CHAPTER 3. INFINITY RULES 29
of empty loops is automatically set to 24 kHz.
This is essential if you are creating live loops using any type of tap
tempo MIDI clock source. The default 24 kHz sample-rate allows for
the MIDI source to speed up and slow down without loosing sync.
Mono Mixdown
Hold Loop 2 during boot to toggle Mono Mixdown.
With Mono Mixdown off (Loop 2 LED is off during boot), the Infinity
Looper outputs in stereo (Default).
With Mono Mixdown on (Loop 2 LED is lit red during boot), both
input channels run into a single output. Both Outputs 1 and 2 will
receive the mono mix of all recorded material.
Stutter
Hold Stop during boot to toggle Stutter.
Stutter replaces the functionality of the Reverse button on the Remote
Switch (see page 33).
With Stutter off (Stop LED is off during boot), the Reverse button
on the Remote Switch functions as expected.
With Stutter on (Stop LED is on during boot), pressing the Reverse
button on the Remote Switch causes the armed loop to be played
from its start point immediately.