Beckett 7590 Gas Power Burner Control - Manual (Page 6)

6
Professional
Service Required
Incorrect installation or
misuse of this control could
result in severe personal
injury, death, or substantial
property damage from explosion or fire.
Read and understand this manual. This
control must be installed, configured
and put into operation only by a qualified
individual or service agency that is:
• Licensed or certified to install and
provide technical service to gas
heating systems.
• Experienced with all applicable
codes, standards and ordinances.
• Responsible for the correct
installation and commissioning of
this equipment.
The installation must strictly comply
with all applicable codes and authorities
having jurisdiction and the latest
revision of the National Fire Protection
Association Standard or CSA Standard
for the installation of gas controls in the
appropriate gas appliance.
Regulation by these authorities
take precedence over the general
instructions provided in this
installation manual.
Explosion, Fire,
Scald, and Burn
Hazard
Can cause severe injury, death,
or property damage.
• The control can malfunction if it gets
wet, leading to an accumulation of
explosive gas vapors.
• Never install where water can flood,
drip or condense on the control.
• Never use a control that has been
wet - replace it.
--------------------------------------
All heating appliances must have HIGH
LIMIT protection to interrupt electrical
power and shutdown the burner if
operating or safety controls fail and
cause a runaway condition.
• Follow the appliance
manufacturer’s wiring diagrams
and note all required safety
controls.
• Typical safety controls include
high temperature or pressure
limits, low water cutoffs, pressure
relief valves and blocked flue
sensing switches.
• Verify all limit and safety controls
are installed and functioning
correctly, as specified by the
manufacturer, applicable
safety standards, codes and all
authorities having jurisdiction.
• Ensure that gas or gas vapors
have not accumulated in the
appliance before starting or
resetting the burner.
Electrical Shock
Hazard
Electrical shock can cause
severe personal injury or
death.
• Disconnect ALL electrical power to
the appliance/burner circuit before
installing or servicing this control.
• Provide ground wiring to the
appliance and burner.
• Perform wiring in compliance with
the National Electrical Code ANSI/
NFPA 70 (Canada CSA C22.1).
Fire or Explosion
Hazard
Can cause severe injury, death,
or property damage.
If You Smell Gas or Believe a Leak May
Exist
• Turn off the manual gas valve to
the appliance.
• Leave the building.
• Do not try to light the appliance.
• Do not touch any electrical switch.
• Do not use a telephone within the
building.
• Leave the building before calling
the appropriate gas organization
Installation