CANOGA PERKINS L351 10/100BASE Media Converter - Manual (Page 29)

EdgeAccess Universal Chassis System
L351 10/100BASE Media Converter 4-10
TRAP CONFIGURATION
1) Master Trap Control Disabled
2) Extension Port Link Traps Enabled
3) Remote Fault Received Traps Enabled
4) Link Loss Forwarding Traps Enabled
5) Link Loss Echo Traps Enabled
6) Remote User Port Link Traps Enabled
7) Local User Port Link Traps Enabled
8) Configuration Traps Enabled
9) Power/Fan/Temperature Traps Enabled
10) Cold Start Traps Enabled
11) Side Band Mgmt Channel Traps Enabled
12) Alarm Input Traps Enabled
13) Diagnostics Traps Enabled
14) Authentication Traps Disabled
Figure 21. Trap Configuration Screen
4.5.4 Alarm Output Configuration
Use the Alarm Output Configuration screen to set any or all alarms to Major, Minor, or Off. See
Figure 22 and Table 5. To configure alarms, follow these steps:
1. From the Main Menu type
3
, "Alarm Output Configuration," and press <Enter>. The Alarm
Output Configuration screen appears.
2. Type the number for the alarm you want to set and press <Enter>.
3. Press <Space> to cycle to Major, Minor, or Off, and press <Enter>.
ALARM OUTPUT CONFIGURATION
1) Factory Defaults
2) Link Down Alarm Off
3) RMTF Alarm Off
4) LLF Alarm Off
5) Configuration Alarm Off
6) Power/Fan/Temperature Alarm Minor
7) SBMC Loss Alarm Off
8) Power-On Self Test Alarm Off
Figure 22. Alarm Output Configuration Screen
Table 5. Alarm Output Definitions
Alarm Description
2) Link Down Loss of Signal (electrical)/Composite Loss of Signal (optical); one
or both received signals fail; default is Off
3) RMTF Remote fault received; default is Off