CANOGA PERKINS N525 Ethernet Termination Service Unit - Manual (Page 41)

N525 Ethernet Termination Service Unit 3-23
Configuring SNMP Access
To set values for basic system parameters, including some parameters used by SNMP, go to
the IP Configuration screen and follow these steps:
1. From the System Configuration Menu type [ 1 ], "IP/SNMP Agent Configuration," and press
<Enter>, then type [ 1 ], "Management IP Configuration," and press <Enter>.
2. At the Management IP Configuration screen, type the number for an item and press
<Enter>. Press <Tab> to highlight the Remote column if needed, then enter data or press
<Space> to cycle through the options. Press <Enter> to select an option.
a. Manager IP Address
Sets the N525 Manager’s IP Address
Subnet Mask
Sets the N525 Manager’s IP Subnet MASK
Default Gateway
Sets the IP Address of the Default Gateway, a network node that manages
connections to other IP subnetworks
b. Test IP Address
Sets the IP Address for Network Performance Assurance optional feature
Test Subnet Mask
Sets the IP Address for Network Performance Assurance optional feature
c. Inband Management Port
Selects which port(s) allow Management Communication access. Parameters are
Both Ports, Ext Port Only, User Port Only, or No Management
d. Management VLAN Tagging
Enables/Disable the use of a Management VLAN
e. Management VLAN Number
When Management VLAN is Enabled, sets VLAN Tag ID
-------------------------------MANAGEMENT IP CONFIGURATION----------------------
Local Remote L357
MAC Address 00 40 2A 00 87 3A
Management Port UP
1) Manager IP Address 172.016.142.225
Subnet Mask 255.255.000.000
Default Gateway 172.016.001.001
2) Test IP Address 000.000.000.000
Test Subnet Mask 255.255.255.000
3) Inband Management Port Both Ports
4) Management VLAN Tagging Disabled
5) Management VLAN Number 1
6) SLIP/PPP IP Address 000.000.000.000
7) Serial Port Config VT100
8) Telnet Security Disabled
Select [1-8]:
------------------------------------Messages------------------------------------