CANOGA PERKINS N525 Ethernet Termination Service Unit - Manual (Page 53)

N525 Ethernet Termination Service Unit 3-35
Configuring Host Access
The N525’s SNMP Agent allows access by up to 24 Host IP addresses. Configuration and
editing the Host information Table is by the Host Access Table Menu. To access the Host
Access Table, follow these steps:
1. From the System Configuration Menu, type [ 1 ], "IP/SNMP Agent Configuration," and
press <Enter> Then type [ 3 ], "Host Table," and press <Enter>.
2. At the Host Access Table Menu, type [a] to add a host. At the prompt, enter the Host IP
Address and Subnet Mask, or type [e] to edit an existing Host.
--------------------------------HOST ACCESS TABLE-------------------------------
Managing Host Telnet FTP SNMP SNMP V1/V2c Rd V1/V2c Wr V1/V2c
IP/Mask Bits Access Access Access Protocol Community Community Access
172.016.002.040/32 All All Write V1/V2c/V3 public private Superv
Select [(A)dd, (D)elete, (E)dit, (M)ore]:
------------------------------------Messages------------------------------------
----------------------------------EDIT HOST ACCESS------------------------------
Managing Host IP : 172.16.2.40
IP Mask Size : 32
1. Telnet Access : Telnet and SSH
2. FTP Access : FTP and SFTP
3. SNMP Access : Write
4. SNMP Protocol : V1/V2c/V3
5. V1/V2c Read Community : public
6. V1/V2c Write Community : private
7. V1/V2c Access Level : Supervisor
Select [1-7]:
------------------------------------Messages------------------------------------