Staking out vertical lines – Leica Geosystems T100 User Manual
Page 25
Advertising
25
T105/T110-1.3.0en
Simple measurements
8
12
Staking out vertical lines
Wanted: Point C should be staked out vertically over B.
SIMPLE method
ACCURATE method
Procedure:
Carry out steps 1 to 3 (see SIMPLE method).
4. Change to face two and aim on point B again.
5. Swivel telescope upwards and mark centre of
telescope (C2) again in the desired height.
Procedure:
1. Set up instrument at any point A. It must be possible to
aim on B and C1 easily.
2. Level up instrument and aim on point B.
3. Swivel telescope upwards and mark centre of
telescope (C1) in the desired height.
Result: Point C is in the middle of the two
markings C1 and C2.
T100Z47
T100Z48
B
C1
2.
3.
3.
B
C1
4.
4.
4.
5.
5.
C
C2
A
A
C
Advertising