Panasonic NV-J35 - Manual (Page 16)

CK (COMT
Using the Remote Controller
When the VTR is in the playback mode, switching over to
Reverse Playback is possible by pressing the Reverse
Playback Button.
• During Reverse Playback, noise bars may appear in the
upper centre and lower centre parts of the picture.
O Super Still Advance Playback
Press the Still Advance Button (!!►) while the VTR is in the
still playback mode. Each time you press this button, the
still-picture will advance one single field.
STILL ADV
mo
O Super Fine Stow Playback
During normal playback, the Slow-motion playback can be
activated by pressing the Slow Button. The slow-motion
playback speed can then be varied by using the Slow
or Button.
When changing the slow-motion playback-^
speed, indicator flashes.
C Z l C
-SLOW-
• Press the Play/x2 Button (►) to continue the normal
playback.
• If the Slow playback operation continues for more
than 5 minutes, the VTR automatically switches over
to the stop mode.
• While playing back a tape in the Super Still or Super
Fine Slow playback mode on a TV set equipped with
an automatic vertical hold control, the picture may
shake vertically. In this case, set the TV set’s vertical
hold (Auto/Manual) selector to the “Manual” position,
and adjust the vertical hold control.
Slow Tracking Control
• When noise bars appear during Super Still, Super Still
Advance or Super Fine Slow playback, switch over to
Slow playback and adjust with the Tracking ( + ) or (-)
Button to reduce the noise bars.
• It may not be possible to eliminate the noise bars com­
pletely.
• The sound will be played back only during normal
playback.
• If you leave the VTR in the Still and Slow playback
mode for more than 5 minutes, the VTR will auto­
matically switch over to the Stop mode to protect the
tape and the video heads.
• Noise which takes the form of horizontal bars ap­
pears on the TV in the Cue and Review playback
modes. This is not an indication of a malfunction.
• The top of the picture may become distorted in the
Cue, Review or Super Still {LP) mode. This is not an
indication of a malfunction.
• When the picture rolls vertically in the Cue or Re­
view mode, adjust the vertical hold control on the
TV set.
• Immediately after starting Cue or Review playback,
the picture may be distorted. Also, when these
modes are cancelled, some momentary picture
distortion may occur, However, this is not due to
any malfunction.
• In “LP” mode only;
1. During any playback mode other than normal
playback, the picture distorted and black and
white. This is not indication of malfunction,
2. When playing back a tape which was recorded
on another VTR, it may be necessary to adjust
the Tracking Control. In some cases the picture
quality may still be inferior. This is due to limita­
tion of format.
€
#
16;