Panasonic NV-J35 - Manual (Page 19)

9
Repeatedly pressing this button will change the indication in
the following order; "M” (Memory)-^ “R” (Repeat)-> “S"
(Search)—> both indications are off ^ “M”.,.
Ctock/Counter Selector
By pressing this button when the VTR On/ Off Switch is set
to “On", it is possible to change over the display mode of
the Clock/Counter Display in the Multi-Function Display
from “Clock" to “Counter” Display and vice versa.
• Even if the selector button is set for "Counter" the display
will automatically changes over to “Clock" Display in all
the following cases; When you set the VTR On/Off Switch
to “Off", adjust the clock to present time, programme a
timer recording, check a timer recording programme or
programme and perform an OTR.
• When the Clock/Counter Display shows the time, the
counter cannot be reset and the Memory and Search
Function cannot be activated (“M", “R" and “S" indication
does not light up.)
Noise Filter/Edit Selector
EDIT ON: For editing operations such as dubbing.
OFF; For ordinary use of the VTR.
NOISE FILTER ON; For playback of tapes with inferior
picture quality caused, for example, by repeated dubbing.
\
• When the Noise Filter/Edit Selector is set to “EDIT
ON", the picture sharpness cannot be adjusted with
the Picture Sharpness Control.
Monitoring Function
When the Monitor Button is kept pressed during Playback
or Still playback, the broadcast picture of the selected pro­
gramme position (channel) or input signal through Audio/
Video Input Socket will be displayed. When this button is
released, the picture will change back to the playback
picture of the tape.
Vertical Lock Adjustment
If vertical jitter occurs during Still playback, adjust the
V-Lock Control (on the rear of the VTR) for the correspond­
ing recording tape speed with the screw driver. A one-time
adjustment should be all that is necessary.
Memory Function
The Memory function makes it simple and fast to find a
certain position on the tape later again, simply by pressing
the Reset Button at that position to set the tape counter to
“O'.OO.OO" and by pressing the Memory/Repeat/Search
Button, During Rewind or Fast Forward, the tape will then
stop at approximately the desired position.
COUNT
M
Memory Indication
J
• Even if the Clock/Counter Display is switched over to
“Clock" Display after pressing the Memory/Repeat/
Search Button, the Memory function will stop the tape
at the desired position.
19)