Panasonic NV-J35 - Manual (Page 31)

DUBBING (COPYING)
A
Dubbing (copying) from one video cassette to another.
• To assure smooth, noiseless cuts when interrupting
the recording, always use the Pause/Still Button
(II).
• To obtain smooth cuts when starting the recording
from the stop mode;
1. Play back the last part of the previously recorded
material to confirm its ending point, and then
press the Pause/Still Button
( I I ) .
2. Press the Record Button {#).
(The VTR is still in the pause mode.)
3. To start recording, press the Pause/Still Button
( I I ) again.
•The picture quality of a re-recorded tape is not as
good as that of the original.
• Disconnect all cables from the Video Input and Au­
dio Input sockets after finishing the recording. If
they remain connected, it is impossible to record TV
programmes.
AUDIO IN VIDEO IN
O
Preparation
• Make the necessary connections as shown in the connec­
tion diagram.
• Press the VTR On/Off Switches to turn both VTRs on.
• Make sure that the Noise Filter/Edit Selector of both the
recording and playback VTRs (if equipped) are in the
“EDIT ON” position. Set these switches to “OFF" for or­
dinary use of the VTRs.
(The Noise Filter/Edit Selector is on the front panel.)
^ Place the recorded cassette in the playback VTR and a
blank video cassette with the erasure prevention tab
intact in the recording VTR.
o Press the Record Button (♦) on the recording VTR.
Q Press the Play/x2 Button (►) on the playback VTR.
Q Press the Stop Button (■) on both VTRs to stop the
dubbing.
:31: