Panasonic NV-J35 - Manual (Page 32)

DUBBIN (CONF
I
Connecting to a VHS^VK&-C Movie Equipped: wittt
Synchro Edit Function
It is possible to synchronize the playback start and stop of
the VHS/VHS-C Movie with the recording start and stop of
this VTR.
Preparation
• Make the necessary connections as shown in the con*
nection diagram.
• Set the Edit Switch (Noise Filter/Edit Selector) on both the
VHS/VHS-C Movie and on this VTR to “ON” (or “EDIT
ON”).
^ Put the VTR in the recording pause mode.
^ Put the VHS/VHS-C Movie in the still playback mode.
• Put the Movie at the point where you want to start
editing into the still playback mode.
0 Press the Pause/Still Button on the VTR.
•The VHS/VHS-C Movie changes over to the piayback
mode and the dubbing will start automatically.
To Leave Out Unwanted Scenes
(T) Press the Pause/Still Button on the VTR.
• The VTR changes over to the recording pause mode
and the VHS/VHS-C Movie changes over to the still
playback mode.
Operate the VHS/VHS-C Movie to skip the unwanted
scenes and then put it in the still playback mode again.
Press the Pause/Still Button on the VTR.
• The dubbing will restart.
To stop the dubbing, press the Stop Button on the VTR and
then put the VHS/VHS-C Movie in the stop mode.
C
/32)