Panasonic NV-J35 - Manual (Page 27)

Transmit the Programming Data Timer On/Off
O
Keep pressing the Transmit Button and confirm that the
programmed data on the Multi-Function Display of the VTR
are as desired.
After releasing the button, the data will continue to be dis­
played for about 12 seconds.
• If the transmission was not received correctly, the
“Beep-Beep, Beep-Beep’’ sound from the VTR will warn
you. in this case, perform transmission again,
•The transmission is possible when the VTR is turned on
but is not in any of the recording or playback operation
modes. It .is also possible when the VTR is in the timer
recording standby mode ([g indication is lit),
• The programming will be done on the next lower unoccu­
pied timer programme number (8-^ 1).
• If all programme numbers are occupied, the “Beep-Beep,
Beep-Beep’’ sound from the VTR will warn you that the
programming cannot be made.
• When the Transmit Button is pressed, the VTR will auto­
matically be put into the timer recording standby condition
and the VTR wiil be turned off.
• To operate the VTR before the timer recording will be
performed, press the Timer Record Button to suspend the
timer recording standby condition. After using the VTR, be
sure to press the Timer Record Button again, otherwise
the timer recording will not be made.
After programming a timer recording, the VTR is in the timer
recording standby mode and cannot be used for any other
operation, such as playback. If some other operation is
desired, first trace the “TIMER ON/OFF” bar code and
transmit it to the VTR with the Transmit Button.
To later reset the VTR to the timer recording standby mode,
trace the “TIMER ON/OFF” bar code again and transmit it
with the Transmit Button.
TIMER ON/OFF
B-
r
L
For Programming More Than One Timer Recording in
Succession
Repeat the following operation steps O~0-
Trace the “CANCEL” bar code on the Programming
^ Trace the bar codes for “CHANNEL”, “DATE”,
“START TIME” and “END TIME”.
o Confirm that the present time is displayed on the
Multi-Function Display of the VTR, and transmit the
data.
• If the next timer programming data are transmitted
while the previous timer programming data are still
being displayed, the displayed timer recording data
will be cancelled.
(27)