Panasonic SC-DV150 - Manual (Page 59)

vi ÏjioOOlfiSs*^ “*
Before requesting service for this unit, check the chart below for a possible cause of the problem you are experiencing. Some simple checks or a
minor adjustment on your part may eliminate the probiem and restore proper operation.
If you are in doubt about some of the check points, or if the remedies indicated in the chart do not solve the problem, refer to the directory of
Authorized Service Centers (enclosed with this unit) to locate a convenient service center, or consult your dealer for instructions.
When the picture of the DVD does not appear on the TV, confirm the region number on the DVD disc.
Confirm the region number at the back of your system, too. page 9)
Problem Probable cause(s) Suggested remedy Page(s)
Common problems
ECO mode is on but the
display panel still lights
up. DEMO mode is on. Turn DEMO mode off.
12
Humming is heard while
playing. AC mains lead or fluorescent lamp is located
in ttie vicinity of cables. Keep electric appliances away from ttie
system.
Try plugging the AC mains lead in the other
way.
/
There is no sound when a
source is being played. The (+) and (-) wire of the speaker cords
are shorted.
Switch the system to the standby mode, and
reconnect the speaker cords so that they are
not shorted. Then switch on the power.
“DTS NO AUDIO” appears
on the display. The disc is encoded with DTS. This system cannot play DTS discs.
Replace the disc.
9
“U70” appears on the
display. Fiat cables are not connected steadily. Connect the flat cable steadily.
When the “U70" display is not cleared after
connecting the unit is damaged. Consult your
dealer.
6,7
“ERROR” appears on the
display. Wrong operation has been done. Operate the unit correctly by following the
operating instructions.
“—:—" appears on the
display. You plugged the AC mains lead in tor the first
time. Set the time.
13
There was a power failure recently.
“OVD U11” appears on the
display. Disc is dirty. Wipe the disc clean.
59
“DVD H appears on
the display.
Trouble is likely to have occurred. The
number following “H" depends on the status
of the DVDA/ideo CD/CD changer.
Turn the system off and then back to on. Alternatively, turn
off the system, disconnect the AC mains lead, and then
re-connect it.
If the display isn’t cleared, consult your dealer about getting
the unit repaired. Tell the dealer the number that was on
the display.
While listening to FM broadcasts
There is a “rushing noise”
during a stereo broadcast
which is not audibie
during a monaural
broadcast.
The transmitting station is a long distance
away. If you are using an indoor antenna change to
an outdoor antenna.
You hear excessive noise
during a stereo broadcast,
and occasionally the
sound disappears. The installation location and orientation of the
antenna are unsuitable.
7
The stereo indicator
flickers and does not light
completely. The transmitting station is a long distance
away.
The sound during a stereo
broadcast is highly
distorted. There is a building or mountain nearby. Use a high-grade outdoor antenna, and install
it in a good location, height, and orientation
for reception.
7
u
I
Q>
«
RQTSOSS