Panasonic SC-DV150 - Manual (Page 6)

El
Connect the flat cables.
1. Connect the shorter flat cable from the tuner amplifier to ter­
minal A1 on the sound processor.
2. Connect the longer flat cable from the cassette deck to ter­
minals B1 and B2.
After connection;
Keep cables as flat against the back of the unit as possible.
Connect the FM indoor antenna.
Tape the antenna to a wail or column, in a position where radio
signals are received with the least amount of interference.
Connect the AM loop antenna.
To minimize noise pickup, bundle the loop antenna cord using
tape or the like to keep the flat cables away from the AM loop
antenna cord.
FI Connect the right (R) and left (L) front speaker
cables.
Use only the supplied front speakers.
The combination of the main unit and front speakers provide the
best sound. Using other front speakers can damage the unit and
sound quality will be negatively effected.
Be sure to connect only positive (red or gray) wires to positive
(-I-) terminals and negative (black or blue) wires to negative (-)
terminals.
Q Connect the surround speaker cables.
0
Connect the center speaker cable.
Connect the video cable(s).
Only for U.K. and Europe
Use the RCAJ adaptor (included) if your TV has 21-pin
SC ART terminal
El
You do not have to connect anyting to the AUDIO terminals.
Except for U.K. and Europe
• Connect a video cable from the MONITOR OUT terminal of
the sound processor to the video input terminal of your TV.
•Connect another video cable from the DVD IN terminal of the
sound processor to the VIDEO OUT terminal of the DVD/
Video CD/CD changer.
□
-rMna To your TV
Connect the AC mains lead.
Insertion of Connector @
Even when the connector is perfectly inserted, depending on the
type of inlet used, the front part of the connector may jut out as
shown in the drawing.
However there is no problem using the unit.
Except (or U.K., Europe, Australia and Now Zealand
If the power plug does not fit your socket, use the power plug
adaptor (included).
S
For your reference
Information you enter into the unit’s memory, except for the
time, remains intact for up to two weeks after the AC mains lead
is disconnected.
Optional antenna connections
You may need an outdoor antenna if you use this system in a moun­
tainous region or inside a reinforced-concrete building, etc.
FM outdoor antenna (not included) El
Remove the FM indoor antenna.
An outdoor antenna should be installed by a qualified technician only.
Connect the outdoor antenna without removing the AM loop antenna.
Run 5 to 12 m of vinyl-covered wire horizontally along a window or
other convenient location.
When the unit is not in use, disconnect the outdoor antenna to pre­
vent possible damage that may be caused by lightning. Never use an
outdoor antenna during an electrical storm.
{
iMi-.
V
I
I
© AM outdoor antenna ¿
(not included) f:
I
I
RQTSOSa