Panasonic NV-HS950AM - Manual (Page 16)

Tunmg the TV to your VCR
The VCR supplies a signal to the TV set via the RF
coaxial cable on channel 36.
It is possible to view the video picture on your TV in the
same way that you watch TV broadcasts.
If you have connected the VCR to the TV through the
21 -pin scart terminal, then you do not need to follow the
procedure mentioned below.
Operations
1
TV VCR
Turn on the TV and VCR.
o
Keep MENU pressed for 5 seconds or
more.
•Press the button until “Ch” appears in the VCR display.
On Screen Display
(During Auto Setup) (After Auto Setup)
Set the TV to an unused position which
you wish to use for your video playback.
•Tune the TV until the test pattern appears on the screen.
• During Auto Tuning, the test pattern screen does not
appear, and the Auto Tuning screen appears instead.
( >
Press STORE to exit the Test Pattern
screen.
Use the remote controller for changing the RF output
channel setting:
If you are encountering interference from a TV broadcast
on this video channel, you may readjust to another free
channel (21-69).
Follow the steps 1 and 2 above.
3 Enter the desired channel number (21-69) by using the
numeric buttons or the v ^ of the remote controller.
•Set the RF output channel of the VCR to “—” (RF
OFF) when the VCR is connected to the TV via the
21-pin scart cable.
Press the “0” numeric button or the n / buttons to
display “—
I----------- >21^...^69<------------------ 1
I------------------ >—^-------------------- 1
(RF OFF)
4 Press STORE to finish the setting mode.
• Retune your TV to the new channel for the VCR.
16