Panasonic NV-HS950AM - Manual (Page 42)

One-Touch-Editing
With this editing, it is easy to perform repeated assemble
editing, insert editing or audio dubbing operations.
Preparations
• Before proceeding with the connections, check that the
AC mains lead of both VCRs have been connected.
• Before the VCR is connected to a movie camera or
another VCR, select One-Touch-Edit to ON.
(See page 24.) The playback VCR display or movie
camera viewfinder image may be abnormal if the edit
cable is connected with One-Touch-Edit left OFF.
•Connect a movie camera or another VCR to this VCR as
shown.
• Use the SYNC/8 mm socket when connecting this unit to
a VCR or movie camera equipped with a LANC socket.
• Insert a recorded cassette tape with an intact erasure
prevention tab.
•Select the video source required by pressing INPUT
SELECT to set A1. A2 or A3.
A1: Through the AV1 (TV) socket.
A2: Through the AV2 (DECODER/EXT) socket.
A3: Through the AV3 (AUDIO INA/IDEO IN/S-VIDEO
IN) sockets.
• Upon completion of the One-Touch-Editing, disconnect
the edit cable.
Recording VCR
Operations
A Press 11 (PAUSE/STILL) on the
■ recording VCR.
2 Search for the end of the previous
recording.
Press REC/OTR to switch the VCR
from the pause mode to the recording
standby mode.
o
•The playback VCR will be in still mode.
• If INSERT or AUDIO DUB is pressed instead of
REC/OTR, Insert Editing or Audio Dubbing can be
performed.
4 Search for the Edit in (starting) point
on the playback VCR.
5 Start One-Touch-Editing by pressing
II (PAUSE/STILL) again.
6 Press 11 (PAUSE/STILL) at the Edit
out (ending) point on the playback
VCR.
• For Editing in succession, repeat 4 to 6.
Press ■ (STOP) to stop editing.
42