Yamaha RX-V730 - Manual (Page 59)

SOUND FIELD PROGRAM PARAMETER EDITING
Changing parameter settings
You can enjoy high quality sound with the factory-set
parameters. Although you do not have to change the
initial settings, you can change some of the parameters to
better suit the input source or your listening room.
Adjustments should be made with the remote control.
\i/
• It is recommended to use on-screen display when changing the
settings.
CD U
s
^ :J—
-
4
2
11 Press AMP.
Turn on the video monitor
O N SCREEN
and press ON SCREEN
1 DISPLAY 1
repeatedly to select the
full display mode.
ET Select a DSP program you want to adjust.
CDWCERT TAtMMENT
m m m m
SPORTS MOVIE THEATER 1 TMEATB3 2
m □□ m cz]
ET
Press /\ / V to select the
parameter.
lil Press < / > to change the
parameter value.
''
• When you set the parameter to a value other than the factory-
set value, an asterisk mark (*) appears by the parameter name
on the video monitor. To reset to the factory-set value, press
< / > repeatedly until the asterisk mark disappears.
IT Repeat steps 3 to 5 above as necessary to
change other program parameters.
Notes
• For some of the programs, the available parameters may be
displayed on more than one OSD page. To scroll through
pages, press ^ / v.
• You cannot change parameter values when “11 MEM.
GUARD” on the SET MENU is set to ON.
Memory back-up
The memory back-up circuit prevents the stored data
from being lost even if this unit is set in the standby
mode, the power cord is disconnected from the AC
outlet, or the power supply is temporarily cut due to
power failure. However, if the power is cut for more
than one week, the parameter value you edited will
return to the factory setting. If so, edit the parameter
value again.
Program No. Program name
Example of the parameter setting display
55