Yamaha RX-V730 - Manual (Page 67)

Tuner
TROUBLESHOOTING
Problem Cause Remedy Refer
to page
FM stereo reception is
noisy. The characteristics of FM stereo
broadcasts may cause this problem
when the transmitter is too far away or
the antenna input is poor. Check the antenna connections.
Try using a high-quality directional FM
antenna. 17
Use the manual tuning method. 35
FM
There is distortion, and
clear reception cannot
be obtained even with a
good FM antenna.
There is multipath interference. Adjust the antenna position to eliminate
multipath interference.
The desired station
cannot be tuned in with
the automatic tuning
method.
The station is too weak. Use a high-quality directional FM antenna. 17
Use the manual tuning method. 35
Previousiy preset
stations can no ionger
be tuned in.
This unit has been disconnected for a
long period. Re-store the stations. 36, 37
The desired station
cannot be tuned in with
the automatic tuning
method.
The signal is weak or the antenna
connections are loose. Tighten the AM loop antenna connections
and orient it for best reception. 17
Use the manual tuning method. 35
AM
There are continuous
crackling and hissing
noises.
Noises result from lightning,
fluorescent lamps, motors, thermostats
and other electrical equipment. Use an outdoor antenna and a ground wire.
This will help somewhat, but it is difficult to
eliminate all noise. 17
There are buzzing and
whining noises
(especiaiiy in the
evening). A TV set is being used nearby. Move this unit away from the TV.
Remote control
Problem Cause Remedy Refer to
page
The remote control
does not work nor
(unction properly.
Wrong distance or angle. The remote control will function within a
maximum range of 6 m (20 feet) and no more
than 30 degrees off-axis from the front panel.
7
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit. Reposition this unit.
The batteries are weak. Replace all batteries with new ones. 3
The manufacture code has not correctly
set.
Set the code correctly. 49
Try setting another code of the same
manufacturer.
—
Even if the manufacturer code is
correctly set, there are some models that
do not respond to the remote control.
—
63