Yamaha RX-V730 User Manual
Page 66
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TROUBLESHOOTING
Problem
Cause
Remedy
Refer
to page
No sound from the rear
center speaker.
“1C REAR LR” or “ID REAR CT” on
the SET MENU is set to NON.
Select ERG or SML.
43
The Dolby Digital EX decoder or the
DTS-ES compatible decoder is not on.
Press the EX/ES button on the remote control to
turn it on.
29
A “humming” sound
can be heard.
Incorrect cable connections.
Firmly connect the audio plugs. If the problem
persists, the cables may be defective.
10-16
No connection from the turntable to the
GND terminal.
Connect the grounding cord of your turntable to
the GND terminal of this unit.
—
The volume level is low
while playing a record.
The record is being played on a turntable
with an MC cartridge.
The turntable should be connected to this unit
through an MC-head amplifier.
—
The volume level
cannot be increased, or
the sound is distorted.
The component connected to the OUT
(REC) jacks of this unit is turned off.
Turn on the power to the component.
—
The sound effect
cannot be recorded.
It is not possible to record the sound
effect by a recording component.
—
A source cannot be
recorded by a digital
recording component
connected to the
DIGITAL OUTPUT jack
of this unit.
A source component is not connected to
the DIGITAL INPUT jacks of this unit.
Connect the source component to the DIGITAL
INPUT jacks of this unit.
The sound field
parameters and some
other settings on this
unit cannot be
changed.
“11 MEM. GUARD” in the SET MENU
is set to ON.
Set “11 MEM. GUARD” in the SET MENU to
OFF.
This unit does not
operate properly.
The internal microcomputer has been
frozen by an external electric shock (such
as lightning or excessive static electricity)
or by a power supply with low voltage.
Disconnect the AC power cord from the outlet
and then plug it in again after about 30 seconds.
“CHECK SP WIRES”
appears on the front
panel display.
Speaker cables are short circuited.
Make sure all speaker cables are connected
correctly.
—
There is noise
interference from digital
or high-frequency
equipment, or this unit.
This unit is too close to the digital or
high-frequency equipment.
Move this unit further away from such
equipment.
This unit suddenly
turns into the standby
mode.
The internal temperature becomes too
high and the overheat protection circuitry
has been activated.
Wait until this unit cools down and then turn it
back on.
—
62