Unavailable channel selection, Found or not found input signals – Panasonic TU-DST50 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
F
eatures
of
the
S
et
-T
op
B
ox
Unavailable Channel Selection
The unavailable channel selection screen is displayed when you select an unavailable
channel. The following is a list of some possible situations where an unavailable
channel selection may occur,
□
Tuning to a channel that is not transmitting any programs.
□
Tuning to a channel that stopped broadcasting programs.
□
The signal strength of the RF signal is insufficient to obtain consistent error free data.
Found or Not Found Input Signals
The unavailable channel selection screen also indicates whether the input signal is
found or not found.
□
Found signal (FOUND) - The tuner has found a signal, however, insufficient and/or
erroneous data is being received.
□
Not Found signal (NOT FOUND) - The tuner has not found a signal, therefore, data cannot
be received.
Displays the channel number.
A channel name and program
Logo indicates
Digital TV
C H A N N E L N O T A V A I L A B L E
I N P U T S I G N A L : N O T F O U N D
I D # 9 E M R 8 3 6 5 2 0 4 7
Indicates an
unavailable
channel was
selected and
whether the
signal
is
found or not
found.
STB Identification Number. Needed for
service calls. (The number shown is an
example only).
Note:
The screen remains displayed for 60 seconds, then is replaced by a blank screen.