On-screen displays (osd), Function & channel display, Warning and instruction displays – Panasonic OMNIVISION PV-8200 User Manual
Page 15: Menu screen, 1 press action to, 2 press at and ► to, Vcr status & clock display, Blank tape/ no video signal indication, At and
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
On-Screen Displays (OSD)
Function & Channel Display
When a function button is
pressed, e.g. PLAY, or
you change channels,
a 4 second display
appears first in large
and then small characters.
Warning and Instruction Displays
These displays will alert you of a missed operation or
provide further instructions.
If no active channels are found
for CHANNEL MEMORY...
(See page 12.)
MO CH FOUND
PLEASE CHECK ANTENNA
CABLE CONNECTION THEN
PUSH VCH CH UP KEY AGAIN
Menu Screen
1
Press ACTION to
display the menu.
2
Press
AT and
► to
make your selection.
--------------- MENU ----------------
SET UP CHANNEL
101OUA/ LANGUE: ENGL I SH
SELECT
: A
▼ KEY
SET :► KEY
END : ACT ION KEY
To get the most from each feature,
please read the Operating Manual
before attempting any operation.
VCR Status & Clock Display
Press DISPLAY to display or remove the
overlay shown below.
Current Time
If you attempt to set or review
a Timer Recording and the
Clock is not set...
(See page 18.)
After a Timer Program has
been set...
(See page 18.)
If you press REC on the
remote control or VCR,
and a cassette is inserted
with no record tab...
(Seepage 17.)
If you press PLAY, FF, REW,
or REC on the remote
control or VCR without
a cassette inserted...
(See pages 16,17.)
If you press PCWER or STCP
during a Timer Recording...
(visible in VCR mode only)
(See page 19.)
If head cleaning becomes
necessary while playing
back a tape...
(See page 5.)
PLEASE SET CLOCK
BEFORE PROGRAMMING
TURN VCH OFF
FOR TIMER RECORDING
CHECK CASSETTE
RECORD TAB
HO CASSETTE
PLEASE INSERT A CASSETTE
TO CANCEL TIMER REC
PUSH POWER THEN STOP KEY
VIDEO HEADS MAY
NEED CLEANING
PLEASE INSERT HEAD
CLEANING CASSETTE
OR REFER TO MANUAL
END:PLAY KEY
Blank Tape/ No Video Signal Indication
Whenever a blank section of a tape comes up in
Play mode, or when the selected channel has no
broadcast signal with the Blue Back ON/OFF
Feature (page 26) set to ON, the TV screen will
turn solid blue.
If you press a function button
other than STOP/EJECT or
POWER while the VCR is in
VCR Lock mode...
(See page 26.)
If you press POWER, ACTION,
or PROG on the remote while
in TV or CABLE/DSS mode...
(See pages 24, 25.)
VCR LOCK ACTIVATED
NOW TV/CABLE/DSS MODE
PLEASE PUSH VCR KEY
ON REMOTE
15