Panasonic OMNIVISION PV-8200 - Manual (Page 18)

Timer Recording
‘Important: If the remote control POWER, ACTION, PROG, CHA/T , INDEX, or ADD/DLT button does
not work when pressed, press the VCR button on the remote and try the button again.
You can set up the VCR to record a one
time, daily, or weekly program while you are
away or otherwise occupied. Up to 8
programs can be stored in memory.
[^^Check list before you begin.
□ All connections are made.
(See pages 6-9.)
n TV and VCR are plugged in and turned on.
□ VCR/TV selector is set to “VCR."
□ Clock is set to correct time.
□ Record tab in place. (See page 5.)
—____ ¿y______________ is ____ __
--------- -
Multi Function Display
VCR TV CABLfc
CO
1
Press PROG*
to display the
program screen.
• If a program is already in memory, press AT
and ^ to select an unused program number.
ièbXi'''...............
ÉÉBBÔËiâHi^
Press
AT
and ► to select and
set one of the following as the DATE;
• 1~31 =One time recording
• DAILY =Same time MON-FRI
• WEEKLY (SUN-SAT) =Same time once a week
SELECT ▼ KEY
SET ;► KEY
END iPROG KEY
Example
Today’s Date
■31“ 1 —2’ ^ 8 — 9 '
7
selecta
/T
Selection Order DAILY
L*,WEEKLY........... WEEKLY___ WEEKLY _J
(SAT) (MON) (SUN)
3
Press
AT
and
to select and set each
of the remaining
items at right.
Remaining Items to be set;
• START time
• STOP time
• CH(annel) number, or LINE
for outside source recording
• Speed (SP, LP, SLP)
To Make Corrections
Repeatedly press ► to move the cursor to the right, or M to
move to the left to the incorrect entry and make the correction.
o U
^ E>J
^ \
•
3
a
fW9t BUÏW
O © g T
0 0 0
0 © ©
AOM>LT
© © ®
“S 0 Qi
mOOUNTDl2№
4
Press PROG to end the program.
• This screen appears for confirmation.
p OT START STOP CH SPD
To Enter More Programs
Press AT and ^ to select and set a blank
program number, and then repeat steps 3 and 4.
Press PROG to exit this mode.
Press POWER off to set the timer.
• When recording programs via a cable box,
make sure the cable box is left ON and
tuned to the desired channel.
CANCEL:ADD/OLT KEY
SELECT 1-8:
a ¥ KEY
ENTER :► KEY
END tPROG KEY
— tlLU^sl —
Multi Function Display
A cassette with no record tab is ejected and “TIMER" flashes when the power is turned off to set the timer.
If the start times of two programs overlap, the tower numbered program will have priority.
If №e start time for a timer recording comes up during a norma) recording or One Touch Recording (page 17),
the timer recording wtti not be performed.
If there is a power interruption of more than one minute, the recording will not be perfotmed or continue.
18