acidlab Robokop - Manual (Page 15)

15
When the Inst./Select Button is held down, the currently selected trigger is
indicated by the LED above the corresponding instrument button. When the
Inst./Select button is released, the pattern of this trigger is displayed by the
LEDs over the Step Buttons (1-16)
Programming and Erasing a trigger
By pressing one of the Step Buttons (1-16) you can write the selected trigger
to that step in the pattern. The LED above the Step Button will light up. When
the button is pressed again, the trigger will be deleted from the step.
Clear Pattern (Pattern Step Write Mode)
The entire pattern can be deleted by pressing the Clear Button and the
Instrument Select button at the same time.
Pattern Length Programming (Pattern Step Write Mode)
By pressing the Length Button and one of the Step Buttons (1-16)
simultaneously, you can choose the last step of the pattern.