acidlab Robokop - Manual (Page 21)

21
MIDI Expander Mode
The Acidlab Robokop can also be controlled using MIDI Note Data.
To use the Robokop in Midi Expander Mode, switch off the power-supply of
your Robokop tabletop-version using the On-Off switch on the left side panel.
If your have the Robokop modular-version, you will have to switch off the
power-supply of the rack from your complete modular-system.
Now hold the the Write/Next [Midi Expander] button and switch the Robokop
back on with the On-Off switch of your Robokop (tabletop version) or of your
complete modular-system (module version).
You can see that you are in MIDI Expander Mode when all 4 Scale LEDs
are illuminated.
Repeat the same process to resume using the internal sequencer!
By pressing the Instr./Select button and the Write/Next [MIDI Expander] button
simultaneously, the Midi-Learn-Mode is activated and will be indicated by a
blinking LED above the Write/Next [MIDI Expander] button.
The first received midi-note sets the midi-channel (1-16) and the LED stops
blinking. The midi-channel will be saved untill a new Midi-Learn-Mode is
activated.
The following MIDI Notes are used to play the Robokop’s triggers:
36 -> Trig 2
37 -> Trig 3
38 -> Trig 4
39 -> Trig 5
40 -> Trig 6
41 -> Trig 7
42 -> Trig 8
43 -> Trig 9l
44 -> Trig 10
45 -> Trig 11
46 -> Trig 12
Velocity values > 100 will put an trigger on the Trig1-/Accent Out.