Analogue Solutions Concussor - Manual (Page 38)

ANALOGUE SOLUTIONS
CONCUSSOR e&oe (c) 12-2007 38
LFO-NZ - VCLFO / NOISE
Inputs: Outputs: Power:
Freq CV Ramp/Rev.Ramp +/-12V
Tri/Square
Noise
LFO Controls: Size:
Ramp/Rev.Ramp Level/Select 6HP
Tri/Square Level/Select
Indicators:
LFO Speed
Introduction
An LFO module with 2 separate waveform outputs, out of a choice of 4. Use an LFO to control
a VCO (to create vibrato), a VCA (for tremelo) or to control a filter's cut-off frequencer (wah-wah
/filter sweep). Use it any where you want to change a module's performance over time.
2 modules in one:
Separate LFO and Noise features
Controls
Speed
This sets the LFO frequency
Ramp / Reverse Ramp Level / Select Switch
Sets the output level to the Ramp out jack of the Ramp signal. Pull the control out to select
Reverse Ramp.
Triangle / Square Level / Select Switch
Sets the output level to the Triangle out jack of the Triangle signal. Pull the control out to select Square.
Sockets
Ramp / Reverse Ramp
Outputs the Ramp or Rev.Ramp signal depending which is selected.
Triangle / Square
Outputs the Triangle or Square signal depending which is selected.
Noise
Direct output of a white noise signal. Use this as a control source for interesting effects, or as an audio source for
wind or percussive sounds when used with a filter/EG/VCA (such as our SY01)
Frequency CV In
This is a control voltage input. The level of the input voltage controls the speed of the LFO. This is good for creating
even more interesting LFO effects. Feed the output of an envelope, like our EG02, into here for an LFO speed that
changes over time. Or use a CV sequencer such as the SQ8 to change the speed on each beat.