Analogue Solutions Concussor - Manual (Page 49)

ANALOGUE SOLUTIONS
CONCUSSOR e&oe (c) 12-2007 49
MCV - MIDI to CV Converter
Introduction
The MCV is a quick and easy to use module that allows control of analogue devices from a
MIDI controller.
Use
Connecting
Connect the MIDI sequencer or other MIDI device to the MIDI input of the M2CV.
Normally CV1 (PITCH) goes to the pitch CV input of your synth. CV2 goes to any other CV
input, like filter cut-off CV. Gate goes to the Gate or Trig ger input o your synth.
Make sure the MCV is on the right MIDI channel and away you go!
Details
The MIDI activity light will be lit whenever there is a gate volt age present (i.e. whenever 1 or
more MIDI keys are held).
The Pitch CV out (CV1) conforms to 1V per Octave.
The controller CV out (CV2) responds to MIDI controller 1 (mod Wheel). It has a 0 to 10V
range. Controller number can not be changed. Resolution is 7 bit.
MIDI Channel Selection
Programming the MCV is a very simple proceedure.
Press and hold the PROG button. Then press a MIDI key.
The MCV will set its MIDI receive channel to the MIDI chan nel the keyboard is trans-
mitting on.
CV2 Control Source Assignment:
If a key was pressed to set MIDI channel, then CV2 will assign to velocity. If a controller was used to set channel,
then CV2 will assign itself to that controller number.